Today, we will explain to you how to solve the problem if the crusher keeps vibrating when using it.
I. The causes of common problems
1. Overload of feeding quantity: the conveying speed of the feeder is too fast, and the processing capacity of the crusher per unit time far exceeds the design standard, and the overload operation of the equipment causes severe vibration.
2. Material blockage/uneven feeding: there is material blockage at the entrance and exit of the equipment, or the feeding is not centered and the raw materials are concentrated on one side, and the unbalanced feeding causes the equipment to swing.
3. The wearing parts are seriously worn: the wearing parts such as hammer head and Hua Lun are excessively worn, which causes the internal operation center of the equipment to shift and rotate unsteadily, and causes the fuselage to swing.
II. The corresponding solutions
1. Adapt to the feeding load: control the feeding rhythm, appropriately reduce the feeding rate, and make the feeding amount match the rated processing capacity of the equipment.
2. Clean and standardize feeding: clean up the blocked materials at the entrance and exit of the equipment in time, adjust the feeding position, ensure uniform feeding in the center and restore the stress balance of the equipment.
3. Replace the wearing parts: directly replace the wearing parts such as hammer head and Hua Lun, restore the overall counterweight of the equipment fuselage, and ensure the smooth operation inside.
Do a good job in daily equipment inspection, regularly clean the passage, check the accessories, and strengthen the foundation to reduce the problem of violent swing from the source.
